You might get your tiles from the good DIY store but check local newspapers for tile warehouse in your area – they'll have more on the screen and can offer you a good discount. You should be able to take your adhesive, grout and tools from the same retailer.

You need a shovel 6mm for wall and 10mm for the floor. 4mm for mosaics. You need an adhesive ready for the wall. You need two empty buckets, a large sponge, grout/squeegee buoys, paddles for mixing powder, tape measure, spirit levels, cheap tile cutters: a diamond wet cutter and cutter may be dry, and scraper.

Check how much this will cost and seriously consider whether it is worth buying: most tilers will only charge a few hundred for an average bathroom or kitchen and then you will not have a tool that roams afterwards. However, before you start your tile installation, it is necessary that you are well prepared for the job. If you are not a DIY person, you can hire professionals to complete the task. You can find expert floor tilers in Perth through https://guntiling.com.au/ 

If you trying to accomplish this job by yourself, the important thing is to measure carefully, using your spirit level to get a horizontal line, first set your pattern and order far more tiles than you think you need! I started on the lines remaining in and around the edge of the tub or from the focal point such as under the lid stove in the kitchen or around the windows.

For the floor, check to see patterns that will allow you the most complete tiling. Consider preparing a dilute PVA on the wet surface area. It is worth looking at the tiles around the commercial stores and your friend's house first to see what you like and dislike. Where the tiles are cut? What stands out? Set one line at a time and then build a wall or across the floor back to the door.

Spread adhesive with a trowel and drag horizontally to store excess pressure. Place the tiles carefully but not too hard. Use matches to place your tiles. Try the brick design to save the hassle of aligning the joint! Leave overnight before installing grouting.

It may look like laying tile is very difficult for those who have ever tried to do before. While working on it, you will probably find that removing and replacing a toilet is the most difficult task. It is going to be a challenge laying these tiles, so you must plan ahead. It is going to take several days finishing the tiles.

When buying tiles, it is better to get larger tiles because it is cheaper. This is a good way to save money if you are on a tight budget. But remember that larger tiles are easy to break so be careful. The first thing you want to do is clean the bathroom floor from any debris. Measure the floor from wall to wall. Tiling is a complex and expensive job, so if you are not a DIY person calling in expert bathroom tilers of Perth would be a great choice for completing a successful tiling project. 

You may need extra tiles if one would be cracked or cut wrong. Once you decide on the type of tile you need, you'll find out how many tiles you need. You may also want to do a dry run to determine the best layout for your tile. Start in the middle and lay the tile outward. Mark the centre of the floor so if you are ready to lay the tiles it is easier for you to find.

Cover the entire floor with cement boards. Mix thin-set mortar but only the amount you will use in an hour to keep the mortar from drying out. Spread the mortar on the entire floor underneath the concrete board. If the bathroom is not square, you can lay tiles diagonal lines instead of vertical or horizontal. Place the tile over the mortar and twist securely. Twisting can remove the trapped air under the tiles. Place spacer around the tile and lay the next tile doing the same step on every tile.